Product ID:ENAMEL ALKYD SEMI-GLOSS 25193 BLUE
MSDS Date:09/22/1986
FSC:8010
NIIN:00-995-6963
MSDS Number: BHWJR

CON-LUX COATINGS, INC.

226 TALMADGE ROAD
EDISON, NJ 08818-0847
US

Emergency Phone: (206) 287-4000

Info Phone: (206) 287-4000

Cage: 60189

CON-LUX COATINGS INC

847 EDISON, NJ 08818-0847 US

Telephone: 732-287-4000

Cage: 60189

MINERAL SPIRITS

CAS: 64742-47-8

Fraction By Weight: 29.63%

OSHA PEL 100 PPM

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

2-ETHOXYETHANOL (EGEE) (SARA III)

CAS: 110-80-5

RTECS: KK8050000

Fraction By Weight: 4.32%

OSHA PEL S,200 PPM

ACGIH TLV: S, 5 PPM; 9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Effects of Overexposure:EYES: MAY CAUSE IRRITATION SKIN: MAY CAUSE
IRRITATION INHALATION: MAY IRRITATERESPIRATORY TRACT CAUSING
HEADACHE, NAUSEA AND DIZZINESS. INGESTION: NK

First Aid:EYES: FLUSH IMMEDIATELY W/WATER SKIN: WASH AFFECTED AREAS
WITH SOAP/WATER REMOVECONTAMINATAED CLOTHING, CONSULT PHYSICIAN IF
IRRITATION PERSISTS. INHALATION: MOVE TO FRESH AIR, TREAT
SYMPTOMATICALLY . INGESTION: DRINK 1-2 GLASSES OF WATERDO NOT
INDUCE VOMITING. IF VOMITING OCCURS KEEP HEAD AT OR BELOW KNEE
LEVEL CON SULT PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY.

Flash Point:105F/40.56CD
Extinguishing Media:FOAM, CO2, DRY, CHEMICAL, WATER MIST
Fire Fighting Procedures:WATER MAY BE USED TO COOL DOWN UNOPENED
CONTAINERS IN VICINITY.
Unusual Fire/Explosion Hazard:CONTAINS FLAMMABLE SOLVENT. DO NOT USE IN
AREAS WHERE SPARKS OR OPEN FLAMES ARE PRESENT.

Spill Release Procedures:ELIMINATAE ALL IGNITION SOURCES. WEAR
APPROPRIATE PERSONAL PROTECTION EQUIPMENT AND APPROVED RESPIRATOR.
CONTAIN SPILL W/ABSORBENT MATL PUT INTO VAP OR TIGHT CONTAINER.
PREVENT MATL CONTACTING ANY WA TER SOURCES OR SEWERS LEADIN TO
SURFACEWATERS.

Handling and Storage Precautions:STORE IN AREAS DESIGNED TO COMPLY WITH
ANSI/NFPA 30 FLAMMABLE AND COMBUSTIBLE LIQUIDS CODE.
Other Precautions:GROUND CONTAINERS WHEN POURING LIQ/POWDERS.
READ/UNDERSTAND MANUFACTURERS SAFETYPRECAUTIONS BEFORE HANDLING.
PROVIDE ADEQUATE VENTILATION/RESPIRATORY PROTECTIONTO REMOVE
DECOMPOSITION PROD. DURING WEL DING, FLAME CUTTING, OR COATING
SURFACES

Respiratory Protection:IN OUTDOOR OR OPEN AREAS, USE APPROVED
RESPIRATOR TO REMOVE SOLID AIRBORNE PAR- TICLES OF OVER SPRAY
APPLICATION. IN RESTRICTED VENTILATION AREAS USE APPROVED
RESPISRATOR DESIGN TO REMOVE A COMBINATI ON OF PARTICLES AND VAPOR.
Ventilation:SUFFICIENT IN VOLUME, PATTERN TO KEEP AIR CONTAMINANT
CONCENTRATIONS BELOW CURRENT APPLIC. OSHA PERMISSIBLE EXPO. UNITS.
Protective Gloves:LONG/REPEATED EXPOSURE: IMPERVIOUS TYPE
Eye Protection:SAFETY EYEWEAR
Other Protective Equipment:PREVENT PROLONGED SKIN CONTACT WITH
CONTAMINATED CLOTHING.
Work Hygienic Practices:WASH HAND BEFORE EATING, SMOKING OR USING
WASHROOM FACILI- TIES
Supplemental Safety and Health
NK

Boiling Pt:B.P. Text:0-323F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:56.99%

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME HEAT, SPARKS OR OPEN FLAMES.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED
Conditions to Avoid Polymerization:EXTREME HEAT, SPARKS OR OPEN FLAMES

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.